| | IPCE Circuit Simulator is TDM OVER IP Device. As long as the IP address of two terminals can recognize each other, then this device can transmit E1 signal via IP network readezvous point and can achieve join monolithically with existing TDM Terminal, Such as PSTN connection, ATM, Frame relay, ISDN, concentrated user exchange and so on. Provides various operation of TDM directly and don' t need change any Terminal.
Product Feature
1. Transmit frame or unframed 1E1-8E1 signal via IP net, Filly compatible with G. 703
2. High transmission rate and low transmission delay
3. Clock revert stably, small dithering and excursion
4. Possess QoS guarantee, supports transmit with date at the same time, assure E1 date prior transmission
5. Convenient to use, don' t need complex setting
6. Transmission package look for address base on IP address and can be configured and revisable
7. Transmission package base on IP date package, shield specific transmission medium, not only can be used in Ethernet / Token-ring or other wired network, but also can be used to increase point to point TDM of wireless LAN. Even can be used in network which mix with wired and wireless
8. Developed a echo counteract device to E1 that it can cancel echo of outside 128ms for some IP transmission network delay is too large and echo problem in voice communication
Setting and Diagnosis
9. Ipce provides menu mode setting service, convenient to use
10. Ipce provides long-distance login connector to set long-distance device via telnet
11. Ipce supports dynamic upgrade, when download new software edition, the old software will be save in backup section. So, if new software be damaged, system can still use old software
12. System provides various alarm: LOS, AIS, LOF and so on
13. Ipce provides local startup auto-inspection, and the inspection result can be observe via super terminal
14. Ipce provides statistic of network affair: date package lose, date package delay, date package wobble and so on
Technologies reference
15. LAN interface:
Port standard: IEEE802. 3, IEEE802. 3u
Port type: RJ45
Port mode: Auto-adapt to 10 / 100M
Protocol: CSMA / CD
16. E1 interface:
Line code: HDB3
Bit rate: 2048KBIT / S + -50ppm
Frame structure: ITU-G. 704, ITU-G. 706
Impedance: 75ohm ( unbalance) or 120ohm ( balance) optional
17. Power
Voltage: 220V AC or-48V DC
Power consumption: | | |
|
)
